scott Astra Newbie
![Astra Newbie Astra Newbie](images/ranks/0.gif)
Joined: 21 Sep 2005 Posts: 19
Location: scotland
|
Posted: Tue Jan 24, 2017 5:20 pm Post subject: Astra mk1 unfinished project 2.0 16v 20xej |
|
|
Up for sale in my unfinished MK1 Astra 1300s project car. B573LMS
Good solid shell but does need some work to make it right.
Rear panel below bumper has rotted away, inner and outer panels need replaced and n/s/r arch has seen better days, just weak not rotten.
There is some dents in the body from being stored.
Just being honest, don't let this put you off it is a solid shell inner wings, bulkhead floor and the rest is solid.
This is a complete car but is in bits, here is the spec
Engine 20xej from mk2 astra GTE (early spec distributor engine)
Freshly painted engine block looks new
Been bored out by 0.5mm new pistons and rings
Good crank polished with ACL race bearings
Decked block
New seals and gaskets through out
Coscast cylinder head, skimmed with 16 new valves all re-ground by hand
new valve stem seals
Standard inlet and exhaust in good condition
Courtney (irmsher) power cap
FSE fuel pressure regulator with gauge
New 10mm (red) Magnecor Race Plug leads
Good wiring loom and ECU x2
Engine is not built yet but hoping to have this done early next week and have it in the car running for being sold!!
F16 gearbox from calibra 2.0 8 valve
Equal length drive shaft wit good cv joint
Poly bushed quick shift linkage with cavalier GSI Gear stick and linkage rod
Don't think I have a clutch for it!
Suspension
Koni yellow top adjustable shock front and rear new done no milage
jamex springs 30-40mm lowering
Poly bushes apart from front suspension arm rear bushes (bought the wrong ones) new 0 milage
MK2 16 valve front anti roll bar
MK2 16 valve rear axel with 2 anti roll bars
Front Big Block GTE strut casings/hubs
Brakes
V6 front calipers pads are ok but discs are worn
Mk2 16 valve rear calipers discs need replaced
New Goodrige stainless brake hoses
Will be sold with 17" TSW Imola alloys will need refurbed
Full MK1 GTE Body kit with spare set of arches, 1 spare side skirt and front splitter
MK1 GTE interior 1 of the seats needs repaired
Door cards are not the best had speaker holes cut in them
Back Carpet in good condition no holes or rips
Dash with glove box plastic trim, heater contols it is in ok condition
All glass including GTE opening rear windows with seals
Rear side window alloy surrounds and both rear side vents all in good condition
New GM headlights
Smoked front indicators
Looking for offer as not sure what it is all worth but would like to sell it complete as I am giving up my storage unit at end of February and moving on! Have invoices for engine machine work done by Agra Engineering in Dundee and will take picture through the engine build (if I manage to do it)
Should have more invoices for suspension
Going to upload pictures on my face book page this should link you with it
https://www.facebook.com/scott.weir.376 |
|